The Room-by-Room Hunt: UGA's Mold and Moisture Home Inspection Checklist
UGA Cooperative Extension's Mold and Moisture Home Inspection Checklist (C1083, Turner & Bailey) walks a home the way an inspector does — basement and crawl space, exterior and yard, floors, ceilings, windows and walls, kitchen and bathroom, attic, appliances — with a test or a number on nearly every line: humidity over 50 percent means dehumidify, a wet area dries within 24 to 48 hours, crawl-space soil gets a 6-to-8-mil vapor barrier, downspouts run 6 to 10 feet from the foundation, the grade drops about 6 inches over 6 to 10 feet, and a bathroom fan proves itself by holding a single sheet of toilet paper. It opens with a caution this site prints on its own inspections too: searching can spread what you find.
Setting: houses — a self-inspection instrument, printed here because the same rooms fail in gyms for the same reasons. Source score: 8/10. This page is our original summary of a published Extension checklist. It is general information, not professional advice.
Source: University of Georgia Cooperative Extension, “Mold and Moisture Home Inspection Checklist” (Publication C1083; Pamela R. Turner, Ph.D., and Lindsey Bailey, M.Ed., UGA Department of Financial Planning, Housing and Consumer Economics; published March 2023, updated September 2026). It is the field companion to the prevention playbook summarized at Preventing Mold in Your Home — that publication names the strategy; this one hands you the walk.
The caution comes first — before any room
The checklist opens with a warning most inspection guides bury: investigating possible mold can disturb contaminated areas and spread contamination through the rest of the home, a serious risk for people with compromised immune systems, asthma, or allergies — so consult a doctor or hire a professional before a thorough investigation, and if you search yourself, use appropriate safety gear as the EPA recommends. The premise under the whole document is stated in its first paragraph: spores need only a comfortable environment, food, and moisture; left undetected or untreated, growth can lead to allergic reactions, respiratory infections, and more (the checklist’s framing, attributed here as it prints it). Documentation begins with not making the exposure worse — a rule this site’s field kit states for gym reporting in the same terms.
Basement and crawl space — where the numbers start
Ceiling, joists, and stairs inspected for growth. Humidity checked with a moisture meter or humidistat: over 50 percent, consider a dehumidifier — and empty and clean its drip pan regularly (a dehumidifier with a foul pan is a reservoir with a fan). Peeling paint, imperfections, and discoloration read as moisture evidence: find the source, eliminate it, and dry the area within 24 to 48 hours — the same two-day clock NIOSH prints for wet material. Foundation cracks checked inside and outside, because they may lead through. Sump pump functioning, floor drain intact. And the crawl space itself: inspected for leaks, properly sealed, with at minimum a 6-to-8-mil plastic vapor barrier covering the soil — ground evaporation answered with a sheet of plastic and a number, exactly as the crawl-space literature on this shelf prescribes.
Exterior and yard — the water’s approach route
Gutters and downspouts intact, clear, directing water away — downspouts extending 6 to 10 feet from the foundation. Pooling water on the roof or around the foundation read as a drainage failure, not a puddle. Slope and grade: about 6 inches of fall over 6 to 10 feet, away from the house. Siding and exterior paint checked for peeling, chipping, bubbling, and visible growth on the house itself. Roof for missing or curling shingles — with the honest note that you may need to hire a professional to inspect it. Flashing around doors, windows, and joints in good condition. Outside dryer vent unblocked. Sprinklers spraying grass, not the house. Foundation plantings not overwatered, thinned if too many crowd the wall. Every line is the same question asked from outside: does the site’s water arrive at the foundation, or is it sent away first?
Floors, ceilings, windows, and walls — reading surfaces
Ceilings and walls for discoloration, sagging, bowing, wet spots — and if there is a dropped ceiling, lift the tiles and inspect the cavity (the space above a drop ceiling is where locker-room moisture goes to be forgotten). Condensation on windows or walls read as a sign of high indoor humidity. Window frames for leaks and peeling drywall. Carpet: lift a corner and inspect the underside. Vinyl wallpaper: look behind it — a vapour-closed skin over a damp wall is a growth chamber with a pattern on it. Closet mold answered as a ventilation problem: leave the door open, and if the closet is full, remove about a third of the contents so air can move.
Kitchen and bathroom — the wet rooms, with a fan test
Caulking, grout, and tiles inspected and repaired. Plumbing leaks hunted around sinks, tubs, refrigerator, dishwasher, and showers. Then the checklist’s best small instrument: check exhaust-fan suction with a single sheet of toilet paper — fan running, paper held in front of it; if the paper stays in place, the fan is working. A fan that cannot hold a tissue is a decoration, and the checklist makes the test take five seconds. Fans must vent to the outside of the house, not into an attic or wall void. Habit check: does everyone turn the bathroom fan on when showering or bathing — and if there is no fan, open the window. Cabinets, drywall, and wood checked for mold and musty smells, with a professional’s moisture meter suggested where suspicion outruns the eye. Refrigerator drip pan cleaned and emptied. Translate this section to a gym unchanged and it is a locker-room inspection: grout, plumbing chases, fan performance measured not assumed, and exhaust that actually leaves the building.
Attic and appliances — the machinery rooms
Attic: moisture damage, leaks, proper ventilation; exhaust ducts directing air to the outside; soffits unblocked (they are the intake half of the attic’s breathing); walls, joists, and insulation checked for musty smell or visible mold. Appliances: a water-heater drip pan, installed if absent, emptied and cleaned regularly; heating and cooling systems serviced by a professional twice a year, coils checked for visible mold; water-heater and washing-machine lines checked for leaks; dryer venting to the outside. The checklist treats HVAC as a moisture appliance, not just a comfort appliance — twice-yearly service with eyes on the coils is its maintenance floor.
The closing rule — and its test scepticism
The “other” sources are listed without ceremony: many plants, large aquariums, laundry hung indoors to dry, an unvented heater — the household moisture income nobody itemizes. Then the rule the whole walk serves, printed as the checklist prints it in substance: anywhere you smell a musty, earthy odor or see excess moisture, there is potential for mold growth — find the source, fix the problem, remove contaminated items, clean with soap and water, and speed-dry. And its final discipline, which this site shares: generally there is no need for a mold test — identify the source, repair it, and that resolves the problem. A checklist that ends by refusing to sell you a test is a checklist written by people whose product is the building’s condition, not the sample. That is why it is on this shelf — and why the same walk, done in a locker room with the fan test and the humidity number and the lifted ceiling tile, produces the kind of record a report can carry.
Tools for this job: Measure — moisture is the whole game
Pinless moisture meter
What it is: A handheld meter that reads moisture inside drywall, wood, and flooring through the surface — no pinholes, no damage. The tool that finds the wet wall behind the paint.
Why it is listed: Moisture readings are the hardest evidence to argue with. A dated photo of a meter reading on a wall turns a landlord dispute from opinion into documentation.
Its limits: Readings are relative and material-dependent — use them comparatively (wet spot vs. known-dry spot) and record both. A meter finds moisture, not mold.
Thermo-hygrometer / humidity data logger
What it is: A room thermometer-hygrometer; the logging kind records humidity over days and weeks instead of showing a single moment.
Why it is listed: A log beats a snapshot. Two weeks of humidity history above 60% is a document; a glance at a dial is an anecdote.
Its limits: Cheap sensors drift — sanity-check a new unit against a second one. Placement matters: measure where people live and sleep, not next to a shower door.
Some links in this strip are affiliate links and cost you nothing extra if you buy through one. As an Amazon Associate I earn from qualifying purchases. Affiliate money never buys scores, coverage, or silence — see our affiliate disclosure.
Read it at the source: UGA Cooperative Extension — Mold and Moisture Home Inspection Checklist (C1083). Companion: Preventing Mold in Your Home (C1047-1).
If this happened to you
Walked your own building with a checklist like this and found the wet corner, the dead fan, the growth behind the wallpaper? File a report with the room-by-room facts and the numbers you measured: dated checklist findings are evidence in a way “it smelled bad” can never be.
Not professional advice. This page summarizes one published Extension checklist for general information. The checklist’s own caution stands: people with compromised immune systems, asthma, or allergies should consult a doctor or hire a professional before investigating mold.